Rockwell Automation 2711-L6Cxx_B6Cxx PanelView 600 Terminals Installation Instructions - Manual (Page 8)

8 PanelView 600 Terminals
Publication 2711-IN010G-EN-P - February 2009
Install the Terminal in a Panel
To install the PV600 terminal in a panel:
1. Cut an opening in the panel using the panel cutout provided with the
terminal. Remove any sharp edges or burrs.
2. Make sure the terminal sealing gasket is properly positioned on the terminal
as shown below. This gasket forms a compression type seal. Do not use
sealing compounds.
3. Although the keypad legend strip can be installed at any time, we
recommend that you install it after the terminal is installed.
4. Place the terminal in the panel cutout.
ATTENTION
•
Disconnect all electrical power from the panel before making the cutout.
•
Make sure the area around the panel cutout is clear.
•
Take precautions so that metal cuttings do not enter any components that may
already be installed in panel.
•
Failure to follow this warning may result in personal injury or damage to the panel
components.
Sealing Gasket