Rockwell Automation 2711-L6Cxx_B6Cxx PanelView 600 Terminals Installation Instructions - Manual (Page 9)

PanelView 600 Terminals 9
Publication 2711-IN010G-EN-P - February 2009
5. Install the 4 mounting clips (2 on top, 2 on bottom); the ends of the clips
slide into the slots on the terminal. Tighten the clip mounting screws by
hand until the gasket seal contacts the mounting surface uniformly.
6. Alternately tighten the mounting clip screws to a torque of 1.13 N•m
(10 lb•in). Do not over–tighten.
7. Remove the 2 protective labels covering the top vents of the terminal.
ATTENTION
Tighten mounting clips to a torque of 1.13 N•m (10 lb•in) to provide a proper
seal and to prevent potential damage to the terminal. Allen-Bradley assumes no
responsibility for water or chemical damage to the terminal or other equipment
within the enclosure because of improper installation.
ATTENTION
Remove the protective installation labels covering the top vents to prevent
overheating and damage to the terminal.
Protective Installation Labels
Install 4 Mounting Clips:
Top - Left and Right Slots
Bottom - Left and Right Slots