Rockwell Automation 2090-xxx Fiber Optic Cable Installation and Handling Instructions - Manual (Page 23)

Fiber Optic Cable Installation and Handling Instructions 23
Publication 2090-IN010C-EN-P – April 2005
0 = Set Continuous Light
1 = Set Zero Bit Stream
2 = Set High transmission power level
3 = Set Low transmission power level
Source Length: must be set to 2 bytes.
Destination Field: The resp_string must be set to a INT array of 1.
There is no response specific data for this instruction.
Message Instruction Communications Tab
Click on the Communication Tab to access the Message Instruction
Communication screen.
Figure 16 Message Communication Screen
At this screen you set the path to the module. Use the browse button to find
the module then set the Path to the module.