Rockwell Automation 6181 Installation Instructions - Manual (Page 16)

16 6181 Industrial Computer
Publication 6181-IN002C-MU-P
Panel Mounting with Mounting Clips
To install the 6181 Computer in a panel using mounting clips:
ATTENTION: Disconnect all electrical power from the
panel before making cutout.
Make sure the area around the panel cutout is clear.
Take precautions so that metal cuttings do not enter any
components that are already installed in the panel.
Failure to follow these warnings may result in personal
injury or damage to the panel components.
1. Cut an opening in the panel using the appropriate panel cutout
dimensions provided on page 13.
2. Make sure the 6181 Computer sealing gasket is properly positioned on
the terminal. This gasket forms a compression type seal. Do not use
sealing compounds.
3. Place the 6181 Computer in the panel cutout.