Rockwell Automation 6181 Installation Instructions - Manual (Page 17)

6181 Industrial Computer 17
Publication 6181-IN002C-MU-P
4. Install the mounting clips. The mounting clips slide into the slots on
the top and bottom of the 6181 Computer.
Mounting
Clip
5. Gradually tighten the clips one at a time around the bezel using the
specified sequence. Repeat this process at least three times until the
clips are hand-tight and the gasket is compressed uniformly against the
panel.
6. Tighten mounting clips to a torque of 10 in–lbs (1.1 N•m) in the
sequence shown above. Do not over–tighten.