Rockwell Automation 4100-IF2 IF2 I/O Interface to PDM Installation Instructions - Manual (Page 5)

IF2 I/O Interface to PDM 5
Publication 4100-IN001A-EN-P- February 2001
For specific information required by EN 60204, see the appropriate
sections in this publication, as well as the following Allen-Bradley
publications:
•
Industrial Automation Wiring and Grounding Guidelines,
publication 1770-4.1
•
Automation Systems Catalog, publication B111
This equipment is classified as open equipment and must be
installed (mounted) in an enclosure during operation as a means of
reducing user exposure to hazards.
Preventing Electrostatic Discharge
Electrostatic discharge can damage the interface
board if you touch the circuitry or connector pins
without taking precautions. Follow these
guidelines when you handle the interface board:
•
Touch a grounded object to discharge potential
static.
•
Wear an approved grounding wrist strap.
•
Do not touch the connector or connector pins
on the servo board.
•
Do not touch circuit components inside the
servo board.
•
If available, use a static-safe work station.
ATTENTION
!