Rockwell Automation 2755 Atomscan Bar Code Scanner - Manual (Page 34)

A–B
5
Chapter
5–1
Operating the Scanner
This chapter provides information on how to set up and operate the
AtomScan bar code scanner. This includes:
•
Laser Safety
•
Laser-On Indicator
•
Turning the Laser Light OFF and ON
•
Verifying Operation
All products that emit laser light have a safety label attached, as required by
Federal law. It is meant to provide basic information about the potential
hazards of laser light.
Here is a reproduction of the AtomScan scanner safety label:
AVOID EXPOSURE
LASER LIGHT IS EMITTED
FROM THIS APERTURE
LASER LIGHT DO NOT STARE INTO
BEAM
670 nm LASER DIODE
1.0 MILLIWATT MAX
CLASS II LASER PRODUCT
CAUTION
LASERSTRAHLUNG, NICHT IN DEN LICHTSTRAHL
BLICKEN, SICHTBARE LASERSTRAHLUNG.
LASERKLASSE 2
VORSICHT
CAUTION - LASER LIGHT WHEN OPEN - DO NOT STARE INTO BEAM
PRODUCT CONFORMS TO USA DHHS 21CFR SUBCHAPTER “J”
LABEL NO. 11-110002-01
Momentary exposure to Class II laser light is not known to be harmful.
However:
!
ATTENTION: Avoid direct eye contact with the laser beam
when the mirror is not spinning
Avoid prolonged eye contact with the laser beam when the mirror
is spinning.
!
ATTENTION: Never point the beam at other people, or in a
direction where people may be passing.
Chapter Objectives
Laser Safety