Rockwell Automation 2711-T5AxxL1_T6CxxL1 PanelView 550/600 Touch Screen Terminals - Manual (Page 13)

PanelView 550/600 Touch Screen Terminals 13
Publication 2711-IN034 F-EN-P - February 2009
To connect DC power to the PV550/PV600 touch screen terminal:
1. Secure the DC power wires to the terminal block screws.
2. Secure the Earth Ground wire to the correct terminal block screw.
3. Apply 24V DC power to the terminal.
ATTENTION
Explosion Hazard - Do not connect or disconnect equipment while circuit is
live unless area is known to be non–hazardous.
ATTENTION
Do not apply power to the terminal until all wiring connections have been
made. Failure to do so may result in electrical shock.
+
Earth Ground
DC Negative
DC Positive
Power Terminal
Block (fixed)
PV550 shown, PV600 similar