Rockwell Automation 2711-T5AxxL1_T6CxxL1 PanelView 550/600 Touch Screen Terminals - Manual (Page 9)

PanelView 550/600 Touch Screen Terminals 9
Publication 2711-IN034 F-EN-P - February 2009
Installing Terminal in Panel
To install the PV550/PV600 touch screen terminal in a panel:
1. Cut an opening in the panel using the panel cutout provided with the
terminal. Remove sharp edges or burrs.
2. Make sure the sealing gasket is properly positioned on the terminal (as
shown below). This gasket forms a compression type seal. Do not use
sealing compounds.
3. Place the terminal in the panel cutout.
ATTENTION
Disconnect all electrical power from the panel before making cutout.
Make sure the area around the panel cutout is clear.
Take precautions so that metal cuttings do not enter any components that may
already be installed in panel.
Failure to follow this warning may result in personal injury or damage to the panel
components.
Sealing
Gasket
PV550 PV600