Rockwell Automation T8xxx Trusted Communications Interface - Manual (Page 46)

Trusted
TM
Communication Interface T8151B
Issue 21 Apr 10 PD-T8151B 46
5.4. Command Line Diagnostics
The Communication Interface has a front-panel mounted RS232 serial diagnostic port to which the
Engineering Workstation or a lap-top PC can be connected. The diagnostic port also provides an
interface to the diagnostics and on-line monitoring facilities of the Trusted
TM TMR Processor. This
facility is provided for the use of ICS Triplex personnel.
The command line diagnostic interface requires a TC-304-02 maintenance cable and a terminal
program such as Hyperterminal or Teraterm. The serial port settings default to 19200baud, 8 data bits,
1 stop bit and no parity. The module will reply to ‘Enter’ with its command line prompt ci:?.
5.4.1. Top-level commands
Top-level help is obtained by typing h, to either the communication interface or the processor.
Diagnostics Interface Commands:
t - List tasks registered with Diagnostics
v - List module configuration.
h - Display this help screen.
su - Establish super-user privilege.
. - Close established privilege/connection.
- If no arguments, establish connection.
ci:?
The module build data is shown on typing v.
FIRMWARE CONFIGURATION:
8151 Communication Interface O/S Firmware
353570 Build 115
Copyright (c)1997-2006 ICS Triplex Technology
Copyright (c)2003 Enea OSE Systems AB
HARDWARE CONFIGURATION:
Processor revision - 0x80811014
EPLD revision - 0x00000001
ci:?
Password-protected super-user privileges (su) are required in the processor, primarily to connect to I/O
module command line interfaces and for some of the more invasive commands in the communications
interface. These commands are marked with (!).
5.4.2. Task commands
Operating system tasks (processes) which have command-line diagnostics report their presence on
typing t. This is the route to all further communications interface diagnostics. This top-level command
lists all tasks which respond to commands. Note that these tasks and their commands change with
firmware builds, and therefore there is no separate documentation of all task command interfaces.
Tasks Registered with Diagnostics
Registered Task Name Prefix Commands
Trace Diagnostics trc e,d,c,dm,a,h,.
IMB Diagnostics imb h,p
Peer I/O Comms pio s,p,h
Dual Peer I/O dxp s,h
Front Panel Services fps q,d,r,h
Log Server ls h,d,l,b,k
Modbus Slave mbs s,p,r,e,h
Network Variable Manager nvm s,h,r,l
Comms File System cfs l,i,c,d,s,h
UART Connection Manager uart s,r,h
Modbus Master mbm m,s,t,b,l,c,cont,stat,caddr,sadd
TCP Connection Manager tcp s,p,r,ns,ne,nr,close,clog,diag,h
Remote Diagnostics I/F 1.15 h,...
ci:?