Before you begin, Installation and maintenance guidelines – Rockwell Automation MDF-SBxxxx Kinetix 6000M Integrated Drive Motor Installation Instructions User Manual
Page 7
Kinetix 6000M Integrated Drive-Motor 7
Rockwell Automation Publication MDF-IN001B-EN-P - August 2013
Before You Begin
Remove all packing material, wedges, and braces from within and around the components. After
unpacking, check the item nameplate catalog number against the purchase order.
Installation and Maintenance Guidelines
These guidelines advise you on how to install your product for safe and reliable service.
A shaft seal is factory installed on an IDM unit. A shaft seal is required if any of these
environmental conditions exist:
•
The IDM unit is exposed to fine dust.
•
The IDM unit is exposed to fluids, or is attached to an oil-lubricated device.
•
The IDM unit requires an IP65 or IP66 rating.
Replace the shaft seal at or before its expected lifetime of 12 months. Refer to Cables and
Accessory Kits on
for catalog numbers of shaft seal kits.
Refer to Specifications on
for a description of IP ratings.
ATTENTION: Do not attempt to open or modify the IDM unit. This manual describes modifications that
you can perform in the field, but do not attempt other changes. Only qualified Allen-Bradley
technicians can service an IDM unit.
ATTENTION: Damage can occur to the bearings and the feedback device if sharp impact is applied to
the shaft during the installation of couplings and pulleys or when removing the shaft key. Damage to
the feedback device can also result by applying leverage to the faceplate to remove devices mounted
on the shaft. Do not strike the shaft, key, couplings, or pulleys with tools during installation or removal.
Use a wheel puller to apply pressure from the user-end of the shaft to remove any friction fit or stuck
device from the shaft.