Rockwell Automation GV3000/SE AC Drive ControlNet Network Communication Board, M/N 2CN3000 - Manual (Page 100)

8-2 GV3000/SE AC Drive ControlNet Network Communication Option Board
8.2 Communication Error Codes
Table 6.3 defines the error codes that are returned by the drive for Typed Read and
Typed Write messages.
Table 8.2 – Communications LEDs
LED State Probable Cause Recommended Action
Off No power Turn power on
Steady Red (A & B) Faulted unit Cycle power. If the fault persists, contact your Reliance
Electric representative.
Alternating
Red/Green (A & B) Self test None
Alternating
Red/Off (A & B)
Incorrect node configuration Check the network address and other ControlNet
configuration parameters.
Off Channel disabled None; configure for communication.
Steady Green Normal operation None
Flashing Green/Off Temporary error
Node is not configured
Verify that the node number has been set.
Check that the cable is properly terminated.
Verify that the config manager node is working.
Flashing Red/Off Media Fault
No other nodes present on
the network
This channel’s cable is not
as good as the other.
Check media for problems.
Add other nodes to the network.
Never remove the green channel if the other is red;
communication may be lost.
Flashing
Red/Green Incorrect network
configuration Cycle power. If the fault persists, contact your Reliance
Electric representative.
Table 8.3 – Communication Error Codes
Status
Description
ControlLogix ™ PLC-5
Error Extended Error Error
0 0 0 No Error
00F0 0002 -4094 (0xF002) Incomplete address
00F0 0003 -4093 (0xF003) Incorrect address
00F0 0006 -4090 (0xF006) Addressed file does not
exist in target processor
00F0 0007 -4089 (0xF007) Destination file is too small
for number of words
requested
00F0 000B -4085 (0xF00B) Privilege error, access
denied
00F0 000C -4084 (0xF00C) Requested function is not
available
00F0 0011 -4079 (0xF011) Data type requested does
not match available