Rockwell Automation T7832 ICS Regent+Plus Historian Packages for Winterpret - Manual (Page 6)

Historian Package for W INTERPRET (T7832)
6
Industrial Control Services
Using the drop-down menus you can select commands to
configure the sequence of events function block event entries,
control parameters, print the function block and a host of
other configuration operations.
File Menu
The File Menu gives you access to the standard function block
file commands which include: Save Function Block, Revert to
Last Saved, Compile, View Error Messages, Edit Function
Block Description, Edit Function Block Details, Print
Function Block, Print Setup, Log Off and Exit. For more
information on all of these commands refer to Commands
Common to all Function Blocks in Section 5 of the Regent
User’s Guide.
Edit Menu
Add Entry and Insert Entry
Choose Add Entry to create a new event entry at the end of
the list of existing entries. Choose Insert Entry to insert a
new event entry at the current cursor position. Normally the
order of the event entries is not important because they
simply represent the list of discrete events that are to be
monitored and recorded as they change state.
After choosing Add or Insert Entry a dialog box will open
where you can define the variable name for the event entry.
The Add Entry dialog is shown in Figure 2.
Figure 2. Sequence of Events: Add Entry Dialog.
You only need to enter the name of the variable for each
entry. The description of the variable will automatically be
imported by the editor from the I/O, shared variable or system
variable definitions.