Rockwell Automation 20D PowerFlex 700H/S Frame 11 Replacement Power Structure - Manual (Page 15)

PowerFlex® 700S and 700H Frame 11 Replacement Power Structures 15
Step 6: Installing the
Product Identification Label
on New Power Structure All frame 11 replacement power structures are shipped from the factory
without a product identification label on the drive. If you are installing the
power structure in a 700S drive, you should label it with the accompanying
PowerFlex 700S label. If you are installing the power structure in a 700H
drive, you should label it with the accompanying PowerFlex 700H label.
Step 7: Starting the Drive 1. Install the protective covers on the drive. Refer to publication
PFLEX-IN006
…
, Installation Instructions - PowerFlex 700S and 700H
High Power Drives, for assistance in installing these covers.
2. Start up the drive. Refer to the Start Up procedures in the appropriate
publication:
– User Manual - PowerFlex 700S Drives with Phase II Control,
20D-UM006
…
.
– Programming Manual - PowerFlex 700H Drives, 20C-PM001
…
.
! DANG ER Risk of electr ic shoc k and death. Disconnect po wer, w ait 5 min utes and verify DC b us voltage bef ore ser vicing.
Follow instr uctions in man ual bef ore use .
Earth g round required.
! DANGER
Risk of electr
ic shoc k and death. Disconnect po
wer, w ait 5 m inutes and
verify D C bus v oltage bef
ore ser vicing.
Follow instr
uctions in m
anual b efore use .
Earth g round required
.
OR