Rockwell Automation 20D PowerFlex 700H/S Frame 11 Replacement Power Structure - Manual (Page 7)

PowerFlex® 700S and 700H Frame 11 Replacement Power Structures 7
Insulate Terminal X4 on the Rectifier Circuit Board
1. Follow the lettered steps below to insulate terminal X4 on the Rectifier
circuit board (refer to Figure 3 on page 5 for jumper location).
Important: Do not install the screw and washer that was removed from this
connection.
Task Description
Remove the screw from the X4 connection on the Rectifier circuit board.
Insulate the top and bottom of the X4 connection on the Rectifier circuit board.
A
B
X1
X4
X41
X1
X4
X41
Rectifier Circuit Board
A
B
Side View of Power Structure