Rockwell Automation GV3000/SE AC Drive 30-100HP, 230VAC V6.04 Hardware Ref, Install, Troubleshooting - Manual (Page 54)

7-4
GV3000/SE 230 VAC 30-100 HP Drive, Hardware Reference Version 6.04
Figure 7.1 - Two-Wire Start/Stop Sample Control Wiring
TX RX REGULATOR COMMON +15 VDC PHASE A PHASE A NOT PHASE B PHASE B NOT REGULATOR COMMON ANALOG METER OUTPUT REGULATOR COMMON ISOLATED REFERENCE VOLTAGE VDC SPEED REFERENCE mA SPEED REFERENCE ISOLATED REFERENCE GND +24 VDC FUNCTION LOSS RESET STOP START +24 VDC COMMON SNUBBER RESISTOR BRAKING SIGNAL +24 VDC COMMON N.C. RELAY CONTACT N.C. RELAY COMMON N.O. RELAY CONTACT N.O. RELAY COMMON DIGITAL INPUT 8 (REMOTE/LOCAL) DIGITAL INPUT 7 (RAMP1/RAMP2) DIGITAL INPUT 6 (FORWARD/REVERSE) RUN/JOG
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 17 18 19 21 22 23 24 25 26 27 28 29 30 31 16 20
5 K ohm
FWD
REV
FUNCTION LOSS
RUN
JOG
RESET
START/STOP
12 13 14 15
+
+20
—
mA
Remote 4-20 mA
Speed/Torque
Reference
IMPORTANT: A maintained function loss switch
should be used if P.054 (Level Sense Start Enable)
= ON and P.026 (Function Loss Response) = 1.