Rockwell Automation GV3000/SE AC Drive 30-100HP, 230VAC V6.04 Hardware Ref, Install, Troubleshooting - Manual (Page 76)

A-2 GV3000/SE 230 VAC 30-100 HP Drive, Hardware Reference Version 6.04
Table A.3 - Terminal Strip Input Specifications
Signal Type
Speed Reference Input
Digital Inputs (1 - 8)
Terminal(s)
12-15
16
17
18
19
20
21
22
23
24
Specification
5 KW potentiometer (0 to +/– 10 VDC
@ 50 KW input impedance) or 0-20
mA (@250 W input
impedance) with 10-bit resolution.
(Jumper-selectable by jumper J4;
refer to section 2.4.1.)
Note that the drive provides +15 VDC
buffered through a 1.875 KW resistor.
+24 VDC Isolated Supply
Remote/Local (Default)
Ramp1/Ramp2 (Default)
Forward/Reverse (Default)
Function Loss
Run/Jog
Reset
Stop
Start
Table A.4 - Terminal Strip Output Specifications
Signal Type
Analog Output
Snubber Resistor
Terminal(s)
10 - 11
scaled signal
26-27
Specification
0-10 VDC or 4-20 mA
Used with older Snubber Resistor
Braking Kits such as M/N 2DB2010
series that requires a gate turn-on
signal from the drive.
Table A.2 - Environmental Condition
Condition
Operating Temperature (Ambient)
Storage Temperature (Ambient)
Humidity
Specification
0 ° to 40 ° C (32 ° to 104 ° F)
–40 ° to 65 ° C (–40 ° to 149 ° F)
5 to 95% non-condensing