Rockwell Automation 20D PowerFlex 700S/H Fan Inverter Upgrade Kit (Frame 10-11) - Manual (Page 9)

PowerFlex® 700S and 700H Fan Inverter Upgrade Kit (Frame 10-11) 9
Step 5: Removing the
Inverter from the Old
Inverter Assembly
Task Description
Disconnect the cables at connectors X4 (Blue) and X5 (Black).
A
A A
Task Description
Remove two M5 Pozi-drive screws, which secure the inverter board
and its heatsink to the assembly carriage.
Proper tightening torque for reassembly is 4 N-m (35 lb.-in.).
Carefully remove the inverter board and its heatsink from the assembly
carriage.
B
C
B
Right-hand Inverter Shown
Task Description
On center inverter assemblies, using a 13 mm wrench, remove the nut,
which secures the capacitor and fuse block bracket to the assembly.
Then remove the capacitor and fuse block. You will re-use the fuse
block on the new assembly.
Hand tighten this nut during reassembly.
D
=
=
B