Rockwell Automation EK-29000-DPH01 Dual Probe Holder - Manual (Page 5)

Dual Probe Holder 5
Publication GMSI10-UM028A-EN-E - November 2007
Dual Probe Holder Ordering Information
The following items are options for the Rockwell Automation Dual Probe Holder, Cat. No.
EK-29000-DPH01.
Table 1 Dual Probe Holder Items
Rockwell Automation Cat. No. Description
48772-0200 Stainless steel stinger, 2.00 to 3.00 in. (5.1 to 7.6 cm) probe
adjustment range
48772-0300 Stainless steel stinger, 3.00 to 4.00 in. (7.6 to 10.2 cm) probe
adjustment range
48772-0400 Stainless steel stinger, 4.00 to 5.00 in. (7.6 to 12.7 cm) probe
adjustment range
48772-0500 Stainless steel stinger, 5.00 to 6.00 in. (12.7 to 15.2 cm) probe
adjustment range
48772-0600 Stainless steel stinger, 6.00 to 7.00 in. (15.2 to 17.8 cm) probe
adjustment range
48772-0700 Stainless steel stinger, 7.00 to 8.00 in. (17.8 to 20.3 cm) probe
adjustment range
48772-0800* Stainless steel stinger, 8.00 to 9.00 in. (20.3 to 22.9 cm) probe
adjustment range
48772-0900* Stainless steel stinger, 9.00 to 10.00 in. (22.9 to 25.4 cm) probe
adjustment range
48772-1000* Stainless steel stinger, 10.00 to 11.00 in. (25.4 to 27.9 cm) probe
adjustment range
48772-1100* Stainless steel stinger, 11.00 to 12.00 in. (27.9 to 30.5 cm) probe
adjustment range
48772-1200* Stainless steel stinger, 12.00 to 13.00 in. (30.5 to 33.0 cm) probe
adjustment range
48772-1300* Stainless steel stinger, 13.00 to 14.00 in. (33.0 to 35.6 cm) probe
adjustment range
48772-1400* Stainless steel stinger, 14.00 to 15.00 in. (35.6 to 38.1 cm) probe
adjustment range
48772-9024* Stainless steel stinger, 24.00 in. (61.0 cm), for cut-to-length
applications. Probe end is not machined. The end must be machined
after stinger is cut to length.
* The unsupported length of stinger should not exceed 200 mm (8 in) per API 670.