Figure 3 – Rockwell Automation EK-29000-DPH01 Dual Probe Holder User Manual
Page 8
8 Dual Probe Holder
Publication GMSI10-UM028A-EN-E - November 2007
Figure 3 Placement of O-Rings
Install Base on Machine
4. Install the appropriate base o-ring into the grove in the Dual Probe Holder base. See
Figure 3. Use Table 2 on page 7 to determine which o-ring to install.
5. Apply anti-seize compound to the threaded portion of the Dual Probe Holder base
and install the base into the machine casing. Tighten to 55 ft-lb (75 N-m) torque.
Install Reverse Mount Probe Stinger
6. Install the appropriate sensor o-ring onto the base of the threaded portion of the
probe. Use Table 2 on page 7 to determine which o-ring to install.
7. Apply two drops of thread adhesive, such as Blue Loctite 242 (or greater), to the
probe threads.
8. Insert probe cable into the stinger and tighten probe to 66 in-lb (7.5 N-m).