Baumfolder BAUM20: Pile Folder 1st Station (in 2005) User Manual
Page 13
PAGE 13 TP10243-3
4.
Look to the right hand end of the counter display. If an “ 1 “ appears in the display the Easy-
Parameter is turned on. If an “ 0 “ is displayed, the Easy-Parameter is turned off, see Figure E1.
To turn the Easy-Parameter on or off,
Press the
Plus (+) button for the batch
time delay setup.
Pressing this button changes the “ 1 “ to an “ 0 “ and back. This button is found
at the far right side of the top row, see Figure E1.
5.
Press the
Machine Setup button again
in the top row to confirm and exit pro-
gramming mode.
SELECT EASY MODE
Pressing this button enables the selection of either the EASY mode or cYcL mode
Pressing these buttons will toggle between the EASY mode or cYcL mode. Set EASY in
the large display. You will notice that the sheet gap display screen has (3) dashes when the
Easy Mode is on and a number when it is off.
Press the mode selection button again to exit mode selection.
+