Baumfolder BAUM20: Pile Folder 1st Station (in 2005) - Manual (Page 28)

TP10243-3 PAGE 28
Batching Time Adjustment
The batching time adjustments allow the user to select
the time duration associated with the currently selected
output type. Two output types and times are available.
1. Feed interrupt has a range of 0.0 to 9.9 seconds.
2. Speed-up Table has a range of 0.00 to 5.00 seconds.
Select Count Source
The Output Count and Input Count keys select between
count at delivery and feeder, respectively. One key LED
will always be lit in Counter Setup to show the current
count source, see table 8. Chasing LEDs will activate in
the small display signifying the start setup mode. The next
sheet fed through will be timed from leading edge to
trailing edge and the delay time will be set to one half the
sheet time. Please note this must be redone if the delivery
speed is changed.
Table 8. Count Source Selection
Exit Counter Setup Mode
Pressing any of these keys will cause the counter to
change to a new mode.
2.3 Easy Mode and Continuous Cycle
Mode
2.3.1 Easy Mode and Continuous Cycle Mode
Enable EASY mode at parameter P25, see Table 3.
Select Easy Mode
Pressing this button enables the selection of either the
EASY mode or cYcL mode.
+
The batching count source will be the feeder
photoeye.
The batching count source will be whatever is
connected as the delivery photoeye.
0
+
+
Pressing these buttons will toggle between the EASY
mode or cYcL mode. Set EASY in the large display and
press again.
Select Continuous Cycle Mode
Pressing this button enables the selection of either the
EASY mode or cYcL mode
Pressing these buttons will toggle between the EASY
mode or cYcL mode. Set cYcL in the large display and
.press again.
Exit Run Mode
Pressing any of these keys will cause the counter to
change to a new mode.
2.4 Learn Mode
This key places the controller in learn mode. Learn
mode can only be activated if the folder is idle.
The learn mode allows the user to setup the suction
valve controller. Both manual and automatic setup is
accomplished in this mode. The large display (1) shows
two separate data items. The suction mode is shown on the
left and the sheet length is shown on the right. The small
display (2) shows the current gap length. The suction
length display is active. During Learn Mode, the Learn
Mode key LED indicates whether a valid sheet has been
learned.
Table 9. Learn Mode Status
When the LED is on, pushing the sheet start button will
feed a single sheet of paper. If the sheet is fed properly, the
indicator LED will go off. The suction mode will be set to
automatic. The length of the sheet will be set as the current
sheet length. The suction length will be set based on table
11 and the gap length will be set to 4 cm /1.50 inches.
No valid sheet has been read yet, the system is in
Single Sheet mode.
A valid sheet has been read and the DCT500 has
been setup to run. Single Sheet mode is off. Job