Baumfolder BAUM20: Pile Folder 1st Station (in 2005) - Manual (Page 14)

TP10243-3 PAGE 14
SELECT CONTINUOUS CYCLE MODE
It is recommended to use the continuous cycle mode when the job requires more than ½ of
the sheet length to go in the #1 fold plate or if the product has a window that will be sensed
as the trailing edge of the sheet.
The continuous cycle mode allows you to select the SHEET GAP, SHEET LENGTH and
the SUCTION LENGTH.
Pressing this button enables the selection of either the EASY mode or cYcL mode
Pressing these buttons will toggle between the EASY mode or cYcL mode. Set cYcL in the large
display (see figure E1).
SETTING THE SHEET GAP AND SHEET LENGTH
The small 3 digit display shows the current setting for the sheet gap. The number on the
right hand side of the large display (1) represents the current sheet length. Set the sheet
gap and sheet length for the current job.
SETTING THE SUCTION LENGTH
Use the + and – buttons under the 10 segment bar graph display to adjust the suction
length. Each segment represents 5% of sheet length. If 10 segments are illuminated 50%
of sheet length is selected. So, it is important that the sheet length is set properly for the
current job.
Press the mode selection button again to exit mode selection.
+