Baumfolder BAUM20: Pile Folder 1st Station (in 2005) User Manual
Page 20
TP10243-3
PAGE 20
RESETTING THE TOTAL COUNTER
To reset the Total Counter, Press Button
; ensure the red LED is illuminated.
Press Button
and HOLD DOWN for 3 SECONDS,
The Large 8 digit display will begin to Count BACKWARDS from 5.4.3.2.1,
then display CLEARED, the Counter is then ZERO.
You MUST Press and HOLD Button
as the display is counting
BACKWARDS, if at anytime the
ZERO Button is released, the Counter will
display the Last Count Value
NOTE
The Batch counte r will also be reset to 0 by this procedure.
RESETTING THE BATCH COUNTER
Press the Batch counter Button
; ensure the red LED is illuminated.
Press Button
and HOLD DOWN for 3 SECONDS,
The Large 8 digit display will begin to Count BACKWARDS from 5.4.3.2.1,
then display CLEARED, the Counter is then ZERO.
NOTE
The Total counter will not be reset to zero.
TURN OFF BATCH COUNTING:
Press the
counter setup button
and set either the batch size or time dwell to zero.
Exit the counter setup mode by pressing the counter setup button again or any button in the sec-
ond row.