Baumfolder BAUM20: Pile Folder 1st Station (in 2005) - Manual (Page 58)

TP10243-3 PAGE 58
many steel marbles can drive the sheet too hard
and causing feeding problems.
1. Place register holddowns in proper locations for
the sheet width being fed. Note that for 11x17 sheets
being fed in the 11 inch width, place a register
holddown between the LH see-thru guide and the
vacuum wheel to keep air from cupping the sheet and
causing stumbling. Note that the register holddown
with the scale is always located in the center of the
register in front of the vacuum. Be careful when
placing the holddown on the right hand edge of the
sheet to angle the holddown slightly to prevent the
right hand edge from curling up inside and stumbling.
2. Set the Baumsets by inserting strips of paper of the
job that is being run. Only insert the thickness that
corresponds to the tailing or minimum thickness that
the roller must drive without loosing control of the
paper. You need to refer to your hand-folded sample to
follow the paper path See fig 49. Refer also to the
example fold given in Fig. 50 that shows a cut-away
section of the folder and notes the proper foldplate and
Baumset settings for the imposition shown.
Fig. 50
Fig. 49
JOB SETUP EXAMPLE