Baumfolder BaumCut 26.4 (For serials 69H1122 thru 76D1132) - Manual (Page 88)

K6 - 4
Knife adjustment
1. Bring turning knob (i), located beneath the front table, to position "Knife
change".
2. Press both cut buttons and keep them pressed until knife bar stops auto-
matically at the lower position.
3. Loosen center knife bolt (knife should now drop down to the cutting
stick. If necessary use the knife wrench to push down the knife against the
cutting stick).
Attention!
In case the knife does not reach the cutting stick:
Screw the knife bolts in the
upper bore-holes of the knife.
4. Screw-in knife screw at the very left-hand side.
5. Tighten up all knife bolts!
6. Bring turning knob (i) back to "0 - position" (knife bar should return auto-
matically to upper resting position).
7. Insert knife screw at the very right-hand side and tighten it.
8. Move adjusting can (e) to position 1.
9. Finish knife change by pressing key 1.
Adjustment of knife pre-tension
If hard material is to be cut (such as cardboard) it may be necessary to increase
the pre-tension of the knife if the bottom sheet has not been cut through.
Adjusting the knife:
Tool needed: Knife wrench.
Move adjusting cam (e) on the knife bar to position 1 - 3* .
* required position depending on the material to be cut should be found by test
cuts.
6.0 Knife Change
Knife Change
position
"Knife change"
"0 - position"
i
e