Bird Technologies SCC8 Series-Manual - Manual (Page 20)

Setup
6
Connecting RF Power
After installing the Bird High Power Cal Cart, the RF transmission line can
be attached using standard coaxial line coupling kits.
To couple the swivel flange with a flanged RF transmission line refer to
Figure 4 while following the instructions below:
Figure 4 Swivel Flanged Coupling
1. Insert the center bullet and push it in until it is fully seated.
2. Connect the coaxial input in a straight line and push carefully on the cen-
ter conductor to close.
 Note: The swivel flange on the load makes connection independent
of the orientation of the fixed flange on the coaxial input outer conductor.
3. Insert the bolt sets and tighten evenly all around to transmission line
manufacturer’s recommended torque. Use all of the bolts.
WARNING
Never attempt to connect or disconnect RF equipment from the
transmission line while RF power is being applied.
Leaking RF energy is a potential health hazard.
BOLT BULLET LOAD RF COAXIAL LINE