Calculated Industries 4065 v3.0 - Manual (Page 10)

U SER ’ S G UIDE — 9
З ч 1/x — Finds the reciprocal of a number (e.g., 8
З ч = 0.125).
З – Change Sign (+/–) — Toggles the sign of the dis-
played value to positive or negative.
Ç + Pi (
π
) — Constant = 3.141593
Ç • Degrees:Minutes:Seconds — Converts between
D:M:S and decimal degree formats.
Ç 0 Total Cost — Calculates total material cost given a
unit dimension and an entered Per Unit Cost.
З Я Access Preference Settings — Used to access
various customizable settings, such as dimensional
answer formats (see Preference Settings on page
89).
Memory and Storage Functions
Your calculator has two types of Memory:
1) basic memory or semi-permanent, cumulative µ ;
2) non-cumulative Storage Registers (M1-M3).
µ Semi-Permanent Memory — Adds any displayed
number, dimensioned or unitless, to the semi-per-
manent, cumulative Memory. Values can be sub-
tracted from this Memory using
Ç µ (M–). ®
µ will display the value in the Memory. ® ®
will display and clear the value in the Memory. Ç
® will clear the cumulative Memory without dis-
turbing the existing display.
ß 1 – 3 Storage Registers (M1) through (M3) — Stores
the displayed value in non-cumulative, permanent
Memory (e.g.,
1 0 ß 1 ). Good for storing a
single value, for future reference ( ® 1 = 10).
Note: Non-cumulative means it only accepts one value (does not
add or subtract) and a second entered value will replace the first.
Permanent means the value is stored even after the calculator is
shut off. To delete a stored value, enter a new value or perform a
Clear All
Ç x .
4065UG-E-B 6/9/04 1:49 PM Page 9