Calculated Industries 4065 v3.0 - Manual (Page 80)

U SER ’ S G UIDE — 79
Notes on Changing Stored Stair Variables:
To Change Desired Riser Height: If you wish to use a Desired
Riser Height of other than 7-1/2 inches (the calculator’s default),
simply enter a new value. For example, to enter 8 inches, enter
8
i ß 7 . Press ® 7 to review your new entry. This value will
be permanently stored until you change it.
To Change Desired Tread Width: If you wish to use a Desired
Tread Width of other than 10 inches (the calculator’s default), simply
enter a new value. For example, to enter 10-1/2 inches, enter
1 0
i 1 / 2 ß 9 . Press ® 9 to review your new entry. This
value will be permanently stored until you change it.
To Change Desired Floor Thickness: If you wish to use a Desired
Floor Thickness of other than 10 inches (the calculator’s default),
simply enter a new value. For example, to enter 12 inches, enter
1
2 i ß 8 . Press ® 8 to review your new entry. This value
will be permanently stored until you change it.
To Change Desired Headroom: If you wish to use a Desired
Headroom other than 6 feet 8 inches (the calculator’s default), simply
select a new value via the Preference Mode and use the
+ or –
keys to increase/decrease by one inch. See below examples. This
value will be permanently stored until you change it.
KEYSTROKE DISPLAY
1. Select Headroom via Preference Mode:
o o 0.
З Я Я Я Я HDRM 6 FEET 8 INCH
2. Decrease Headroom Height by 2 Inches:
– – HDRM 6 FEET 6 INCH
3. Then increase Headroom Height by 4 Inches:
+ + + + HDRM 6 FEET 10 INCH
4. Return Headroom Height to default of 6 feet 8 inches:
– – HDRM 6 FEET 8 INCH
4065UG-E-B 6/9/04 1:50 PM Page 79