Calculated Industries 4065 v3.0 - Manual (Page 91)

90 — C ONSTRUCTION M ASTER ® P RO / T RIG / D ESKTOP
(Cont’d)
PREFERENCE OPTIONS
3) Volume Display Format – *Standard (if units entered are the
same—e.g., ft x ft x ft—the answer will
remain in this format (cu. ft), but if units
entered are different—e.g., feet x feet x
inches—vol. answer will always be dis-
played in cubic yards)
– Cubic Yards (vol. answers always dis-
played in cu. yards, regardless of unit
entry—e.g., feet x feet x feet = cu. yds)
– Cubic Feet (vol. answers always dis-
played in cu. feet, regardless of unit
entry—e.g., inches x inches x inches =
cu. ft)
– Cubic Meters (vol. answers always
displayed in cu. meters, regardless of
unit entry—e.g., feet x feet x feet =
cu. meters)
4) Stairwell—Headroom – *6 Feet 8 Inch (default)
Height – Use + or – key to increase or
decrease above value by increments
of 1 inch
5) Rake-Wall Descending – *Descending (Rake-Wall studs are
or Ascending displayed from largest to smallest size)
– Ascending (Rake-Wall studs are
displayed from smallest to largest size)
6) Jack Rafters Descending – *Descending (Jack rafters are
or Ascending
displayed from largest to smallest size)
– Ascending (Jack rafters are displayed
from smallest to largest size)
7) Irregular Jack Rafters – *OC-OC (on-center spacing maintained
O-C or Mate on both regular and irregular sides)
– JAC-JAC (regular/irregular Jack rafters
“mate” at the hip/valley, i.e., on-center
spacing not maintained on both sides)
(Cont’d)
4065UG-E-B 6/9/04 1:50 PM Page 90