Calculated Industries 4065 v3.0 - Manual (Page 89)

88 — C ONSTRUCTION M ASTER ® P RO / T RIG / D ESKTOP
After a Clear All ( Ç x ), your calculator will return to the following
settings:
STORED VALUES DEFAULT VALUE
Desired Riser Height 7-1/2 Inch
Desired Tread Width 10 Inch
Floor Height 10 Inch
On-Center Spacing 16 Inch
Weight per Volume 1.5 Tons/Cu Yd
Block Area (except Trig model) 128 Sq Inch
Footing Area (except Trig model) 1.8 Sq Feet
Crown Angle 45.00°
If you replace your batteries or perform a Full Reset* (press O , hold
down x , and press o ), your calculator will return to the following
settings (in addition to those listed above):
PREFERENCE SETTINGS DEFAULT VALUE
Fractional Resolution 1/16
Area Display Standard
Volume Display Standard
Stairway Headroom 6 Feet 8 Inch
Rake Wall Descending
Jack Rafters Descending
Irregular Jack Spacing OC-OC
Exponent Off
Meter Linear Display 0.000
Decimal Degree Display 0.00°
*Depressing the Reset button located above the p key will also perform a Full Reset.
APPENDIX A — DEFAULT SETTINGS
4065UG-E-B 6/9/04 1:50 PM Page 88