Calculated Industries 4065 v3.0 - Manual (Page 11)

10 — C ONSTRUCTION M ASTER ® P RO / T RIG / D ESKTOP
Recall ® Key
The ® key is used to recall or review stored values (e.g., ® p
to recall a previously entered pitch value). It is also used in reviewing
stored settings, or in Paperless Tape and Memory operation (see
below).
® = (Paperless) Tape — Accesses the paperless tape
mode (see “Paperless Tape” page 35), which keeps
track of your past 20 entries. Useful for checking
strings of numbers.
® ® Clear M+ — Displays and clears M+.
® µ Recall M+ — Displays value stored in M+.
® 1 – 3 Recall (M1) through (M3) — Recalls the value
stored in M1, M2, or M3.
Dimensional Measurement Unit Keys
The following keys are used for entering units of measure, with ease
and accuracy:
y Yards — Enters or converts to yards.
f Enters or converts to feet. Also used with the i
and / keys for entering feet-inch values (e.g., 6
f 9 i 1 / 2 ).
Note: Repeated presses of f after Ç toggle between feet-
inches and decimal feet (e.g., 6 f 9 i 1 / 2 Ç f
= 6.791667 feet; press f again to return to feet-inch-fractions).
i Enters or converts to inches. Also used with the /
key for entering fractional inch values (e.g., 9 i
1 / 2 ).
Note: Repeated presses of i after Ç toggle between frac-
tional and decimal inches (e.g., 9 i 1 / 2 Ç i = 9.5
inch; press i again to return to inch-fractions).
/ Fraction Bar — Used to enter fractions. Fractions
may be entered as proper (1/2, 1/8, 1/16) or improper
(3/2, 9/8). If the denominator (bottom) is not entered,
the calculator's fractional resolution setting is auto-
matically used (e.g., entering
1 5 / = or + will
display 15/16, based on the default fractional resolu-
tion setting of 16ths.
4065UG-E-B 6/9/04 1:49 PM Page 10