Calculated Industries 4065 v3.0 - Manual (Page 72)

U SER ’ S G UIDE — 71
(Cont’d)
KEYSTROKE DISPLAY
4. Enter irregular pitch and find irregular Hip/Valley rafter length and
cut angles:
8 i Ç H IPCH 8 INCH
H IH/V 5 FEET 9-11/16 INCH
H PLMB 23.70°
H LEVL 66.30°
H CHK1 41.19°
H CHK2 48.81°
5. Display the o.c. and find the irregular jack lengths and cut angles:
Ç j IJOC 16 INCH *
j IJ1 1 FEET 4-13/16 INCH
j IJ2 2 FEET 9-5/8 INCH
j IJ3 4 FEET 2-1/2 INCH
j PLMB 33.69°
j LEVL 56.31°
j CHK1 41.19°
6. Find the o.c., regular jack lengths and cut angles:
j JKOC 14 INCH *
j JK1 1 FEET 6-1/2 INCH
j JK2 3 FEET 1-1/16 INCH
j JK3 4 FEET 7-9/16 INCH
j PLMB 30.26°
j LEVL 59.74°
j CHK1 48.81°
7. Reset jack rafter Preference Settings:
o o 0.
З Я Я Я Я Я Я JACK ASCEnd
Set Preference to “Descend”:
+ (plus sign) JACK dESCEnd
Set Preference to “Jacks On-Center”:
ß IRJK JAC-JAC
+ IRJK OC-OC
Exit Preference Settings:
o 0.
*Note: The stored on-center spacing is used as the maximum allowable spacing.
Therefore, it is assigned to the side with the largest entered pitch. In this example, the
“irregular” side pitch is larger than the “regular” side pitch; thus, the irregular side is
calculated using the maximum on-center value (16 inches). If the regular pitch side
had the larger pitch, it would require the larger (16 inches) on-center.
4065UG-E-B 6/9/04 1:50 PM Page 71