Metrohm 840 PC Control 5.0 / Touch Control - Manual (Page 243)

4 Parameters
PC Control / Touch Control
231
4.4 Evaluation
A list of measuring points can have various additional evaluations
applied to it. The evaluation (EVAL command) always refers to the last
titration or measurement in the method sequence. Which evaluations
can be used for which titrations and measurements is given in the fol-
lowing table:
Evaluation
Titration
Measurement
EVAL Fix-EP
Fixed end-
points EVAL pK/HNP
pK value
Half neutraliza-
tion potential EVAL MIN/MAX
Minimum/
Maximum EVAL BREAK
Break points EVAL RATE
Rate evaluation
DET pH V, MV, t pK value yes yes –
DET U V, MV, t HNP yes yes –
DET Ipol V, MV, t – yes yes –
DET Upol V, MV, t – yes yes –
MET pH V, MV, t pK value yes yes –
MET U V, MV, t HNP yes yes –
MET Ipol V, MV, t – yes yes –
MET Upol V, MV, t – yes yes –
SET pH V, MV, t – yes – yes
SET U V, MV, t – yes – yes
SET Ipol V, MV, t – yes – yes
SET Upol V, MV, t – yes – yes
KFT Ipol V, MV, t – yes – yes
KFT Upol V, MV, t – yes – yes
STAT pH V, MV, t – yes – yes
STAT U V, MV, t – yes – yes
MEAS pH MV, t – yes yes –
MEAS U MV, t – yes yes –
MEAS T MV, t – yes yes –
MEAS Ipol MV, t – yes yes –
MEAS Upol MV, t – yes yes –
MEAS Conc – – – – –
MEAS Cond MV, t – yes yes –
Only those evaluations which are available for the last titration or meas-
urement before the EVAL command can be inserted in the list of com-
mands. If a titration or measurement is deleted before the EVAL com-