Metrohm tiBase 1.1 - Manual (Page 293)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Database
tiBase 1.1
￭￭￭￭￭￭￭￭ 285
Selection ● | ╳ | ✸ | ￭ | ▲ | No symbol
Default value No symbol
No symbol
Measuring points are not shown.
Note
With curves, for which the distance between to measuring points is
smaller than 5 pixels, the separate measuring points are not displayed
anymore, even if a symbol has been selected. In this case, the graphics
window can eventually be enlarged in order to display the symbols
again.
Symbol color
Selection of the color for the measuring point symbol.
Selection 13 colors | blue
Default value blue
Smoothing
Smoothing
on | off (Default value: on)
Switches smoothing on/off for the curve.
Smoothing factor x axis
Factor for smoothing on the x axis.
Input range 0.01 - 1000
Default value 0.01
Smoothing factor y-axis
Factor for smoothing on the y axis.
Input range 0.01 - 1000
Default value 0.01
Show with original curve
on | off (Default value: off)
If this check box is activated, then the original curve (solid line, same
color) will be shown in addition to the smoothed curve (dotted line).