Metrohm tiBase 1.1 - Manual (Page 32)

2.4 Formula editor
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
24 ￭￭￭￭￭￭￭￭
tiBase 1.1
Command variables
Unless marked otherwise, all of the variables listed here in alphabetical
order are of the Number type.
Note
In the case of variables with Index {x}, the desired number 1…9 must
be entered for x (e.g. .EP{3}.ERC for the third endpoint).
If no index is specified, then the last index will be used automatically
(e.g. .EP.ERC for the last endpoint).
Variable
name
(PC-Control)
Variable
name
( tiBase 1.1)
Description Command
.BM# .BP{x}.MEA Measured value for the break
point x (1…9) in the unit of the
measured value DET, MET, MEAS (without
T/Flow)
.BT# .BP{x}.TEM Temperature for the break point
x (1…9) in °C DET, MET, MEAS (without
T/Flow)
.BD# .BP{x}.TIM Time for the break point x (1…9)
in s DET, MET, MEAS (without
T/Flow)
.BP# .BP{x}.VOL Volume for the break point x
(1…9) in mL DE, MET
.CONC .CONC Concentration of the solution
used for the command (number) DET, MET, SET, KFT, STAT,
STDADD, ADD, DOS, LQH
.MCD .DBL Duration command (total dura-
tion for the processing of the
command) in s DET, MET, SET, KFT, KFC,
STAT, MEAS, CAL MEAS,
STDADD, DOS
.MDC .DRI Current and/or last drift for drift
correction in mL/min SET, KFT, KFC
.MSD .DSC Duration start conditions (time
for processing all start condi-
tions) in s DET, MET, SET, KFT, STAT
.DDC .DTI Time for drift correction (time
from the start of the titration to
the end of the command) in s SET, KFT, KFC
.MCM .EME End measured value (measured
value after processing of the
command) in the unit of the
measured value DET, MET, SET, KFT, KFC,
STAT, MEAS, CAL MEAS,
STDADD, DOS