Metrohm 919 IC Autosampler plus - Manual (Page 30)

3.8 Connecting MSB devices
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
22 ￭￭￭￭￭￭￭￭
919 IC Autosampler plus
USB 1 Contr. MSB 2 MSB 3
T.2400.102
Figure 13 Connecting a dosing device
3.8.2 Connecting a stirrer or titration stand
You can use the following instruments:
￭ With built-in magnetic stirrer (stirring "from below"):
– 801 Stirrer
– 803 Ti Stand
￭ Without built-in magnetic stirrer (stirring "from above"):
– 804 Ti Stand with propeller stirrer 802 Stirrer
Connect a stirrer or a titration stand as follows:
1 Connecting the stirrer or titration stand
￭ Exit the control software.
￭ Connect the connection cable of the magnetic stirrer or of the
titration stand to one of the sockets marked with MSB on the
rear of the control instrument.
￭ 804 Ti Stand only: Connect the propeller stirrer to the stirrer con-
nector (socket with stirrer symbol) of the titration stand.
￭ Start the control software.
USB 1 Contr. MSB 2 MSB 3
Figure 14 Connecting an MSB stirrer