Metrohm 881 Compact IC pro – Anion - Manual (Page 30)

3.6 Rear of the instrument
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
20 ￭￭￭￭￭￭￭￭
881 Compact IC pro – Anion
Warning
In order to avoid damage to the pumps, the transport locking screws
must be remounted each time the instrument undergoes major trans-
port.
3.6.2 Leak sensor
The leak sensor detects escaping liquid which collects in the base tray of
the instrument.
For the leak sensor to function correctly, the following preconditions must
be met:
￭ The leak sensor connector plug (5-2) is plugged into the Leak Sensor
socket.
￭ The instrument is switched on.
￭ In the software, the leak sensor is set to active.
Connecting the leak sensor
Connect the leak sensor as follows:
1 Pull out the leak sensor connection cable (5-3) from the base tray.
2 Plug the leak sensor connector plug (5-2) into the leak sensor con-
nection socket (5-1) on the rear of the instrument.