HCO MB500 - Manual (Page 17)

Page | 16
F.
Remote Control:
This feature allows the user to send a text message command to change the Send Mode.
Once this function is enabled, user needs to input a Receive Time as shown below.
The camera GSM module will boot up automatically every day at the
‘Receive Time’ to
check if there is any text message commands. After processing the text message
command, the camera will send a confirmation text message to the sender phone
number. If multiple commands are received, the camera will only process the last text
message command.
Note: Avoid sending multiple text message commands to camera in one day.
The camera will accept text message commands in the following protocols shown in the
table:
Send Mode Text Message Command Protocol Example
Off C#00#E C#00#E
Instant C#01#NNN#E C#01#008#E
Customized C#02#HHMM#NN#E C#02#0930#05#E
Daily Report C#03#HHMM#E C#03#1230#E
HH means hour, MM means minute, NN or NNN mean Max Number. Taking
"C#02#0930#05#E" for example, this command will change the Send Mode to "Custom"
with receiving time at 9:30 and Max Num. 5.