Sound Devices 702T - Manual (Page 39)

702T User Guide and Technical Information
37
Navigate to the Setup Menu Option TIMECODE: MODE and set it to Off.
2. Press the REC key to begin recording.
3. Pause the recording at any time by pressing the STOP key once. When paused the absolute time and
Record LED will flash.
4. Press the REC key again to continue recording.
5. Press the STOP key twice will finalize the recording. At this point, the file is available for Playback and
the next press of the REC key will begin recording the next incremented take.
Things to consider when using Record Pause:
• Time code must be Off.
• Multi-unit linking using the C. Link connection is not supported.
• Pre-Roll is only added at the beginning of a file or take. Pre-Roll is not added when recording is
resumed from the paused state.
Record Timer
The 702T is equipped with a record start and stop timer. This allows a user to record a take
at a specific time from an unattended recorder. Set the start time in the Setup Menu op-
tion REC: TIMER START then set the record stop time in the Setup Menu option REC: TIMER STOP.
The 702T will only start recording if the recorder is On when the timer start time elapses.
Playback
The 702T has high-resolution playback circuitry and is appropriate for any reference audio applica-
tion. Any file recorded by the 702T can be played back, including MP2, MP3, FLAC, and WAV files.
Whether files were recorded from the 702T or from copied to a CompactFlash card using a card
reader, the 702T will recognize valid audio files. In addition, files copied to CF from a computer can
be played back in the recorder. This is useful when using the 702T as a high-resolution playback
device.
When play is pressed, the 702T defaults to playing the most recently recorded (or played) sound file,
unless another sound file is selected. There are two ways to select sound files for playback.
• Press either the FastForward or Reverse button to put the 702T in to play-stop mode. The file
name display will flash and the FastForward and Reverse buttons can be used to step through
sound files in the currently selected file folder.
• To select files in other folders, press the HDD button to enter the File Viewer. Navigate to the
appropriate file folder by scrolling up and down the file list. Highlight the sound file for play-
back and press play.
AutoPlay
The 702T can be set to play back all valid sound files in a folder. Files will play back in their order
they were placed in the folder. Autoplay can be set with the following options:
• Disabled – auto playback is off
• Play all – all files in the folder will play, then stop when all files have been played
• Repeat one – the selected file will play back continuously until stopped by the user
• Repeat all – all files in the folder will play in succession, then repeat until stopped by the user