Tweco 300 Ultra-Cut - Manual (Page 36)

Manual No. 0-4819 Ultra-Cut 300 3-12 INSTALLATION
3.07 Connect Work Cable and Pilot and Negative Leads
1. Pass the ends of the work cable and pilot and negative leads upward through the leads bracket and then
upward through openings in the connections cover support panel.
2. Refer to the illustration. Connect the leads as shown. Tighten securely. Do not overtighten.
CAUTION
The clear connections cover must remain in place.
There are two work cables and two negative leads to be connected.
PILO
T
WORK
TORCH
Connection Panel
AC INPUT
L1 L2
L3
Work Lead
Torch Lead - To Remote Arc Starter
Work
Torch
Lead Connection Detail
Connections Cover
Support Panel
Art # A-07660_AB
Connections Cover
Pilot
To Cutting Table
Leads Bracket
Pilot Lead -
To Remote Arc Starter