Tweco 300 Ultra-Cut - Manual (Page 39)

Manual No. 0-4819 Ultra-Cut 300 3-15 INSTALLATION
3.10 Connect Fiber Optic Cable
CAUTION
Check the type of internal control module. Use this section for connections to an internal control
module without an external connections cover. Use the preceding section for connections to an
internal module with an external connections cover.
1. Connect one end of each cable to the power supply as shown.
a. Remove the strain relief securing nut from the strain relief on the fiber optic cable(s). Loosen the strain
relief dome nut from the strain relief.
b. Pass the cable connector through the appropriate opening. Slide the strain relief securing nut onto the
cable. Make a loop of the cable; carefully press the cable connector into the appropriate receptacle on the
internal control module.
c. Tighten the strain relief onto the cable(s). Do not overtighten.
Thin nut securing
the through hole
protector
Fiber Optic
Cable
Plug
Art # A-09456