4b.03 recommended cutting speeds – Tweco XTTM-300 User Manual
Page 40
Operation with 5-Knob Automatic Gas Console
4B-2
Manual 0-2912
4B.03
Recommended Cutting Speeds
Cutting speed depends on material and thickness. The following factors may affect system performance:
• Torch parts wear
• Speed
• Gas quality
• Operator experience
• Torch standoff height
• Proper work cable connection
• Alloy content of material
NOTE
This information represents realistic expectations using recommended practices and well-maintained systems. Ac-
tual speeds may vary from those shown in the charts depending on the alloy content of the selected material.
For complete cutting speed chart data refer to the following pages.
!
CAUTION
Information in this section is for the HD3070 System with an automatic gas control with 5 control knobs.
Shield Controls
Preflow Controls
Plasma Control
Art # A-04493
1
2
3
4
5