Cutmaster 40mm, 01 front panel controls / features – Tweco 40mm Cutmaster User Manual
Page 29
CUTMASTER 40mm
Manual 0-5084
4-1 OPERATION
SECTION 4 SYSTEM:
OPERATION
4.01 Front Panel Controls /
Features
See Illustration for numbering Identification
1. Output Current Control
Sets the desired output current. Output settings
up to 60 Amps may be used for drag cutting (with
the torch tip contacting the workpiece) or higher
for standoff cutting.
2. Function Control
Function Control Knob, Used to select between
the different operating modes.
SET
Used to purge the air through the unit
and torch and leads and to adjust gas pressure.
RUN
Used for general cutting operations
RAPID AUTO RESTART
Allows for
faster restarting of the Pilot Arc for uninter-
rupted cutting.
LATCH
Used for longer hand
held cuts. Once a cutting arc is established,
the torch switch can be released. The cutting
arc will remain ON until the torch is lifted
away from the work piece, the torch leaves
the edge of the work piece the torch switch
is activated again or if one of the system
interlocks is activated.
3. ON OFF Power Switch
ON / OFF
Switch controls input power to
the power supply. Up is ON, down is OFF.
4. Air/Gas Pressure Control
The Pressure
+
Control is used in the
"SET" mode to adjust the air/gas pressure. Pull
the knob out to adjust and push in to lock.
5.
AC Indicator
Steady light indicates power supply is ready for
operation. Blinking light indicates unit is in pro-
tective interlock mode. Shut unit OFF, shut OFF
or disconnect input power, correct the fault, and
restart the unit. Refer to Section 5 for details.
A
+
PSI
BAR
MAX
MAX
MIN
MIN
!
1
2
3
4
5 6 7 8 9
Art# A-07886
MIN
MAX
10
6.
Temp Indicator
Indicator is normally OFF. Indicator is ON when
internal temperature exceeds normal limits. Let
the unit cool before continuing operation.
7.
Gas Indicator
Indicator is ON when minimum input gas pres-
sure for power supply operation is present. Mini-
mum pressure for power supply operation is not
sufficient for torch operation.
8.
DC Indicator
Indicator is ON when DC output circuit is active.
9.
!
Fault Error Indicator
Indicator is ON when Fault circuit is active. See
section 5 for explanations of fault lights.
10. Pressure Indicators
PSI
BAR
MAX
MAX
MIN
MIN
80
75
70
65
5.5
85
5.9
90
6.3
5.2
4.8
4.5
Art # A-08170
The Indicators will illuminate
according to the pressure set by the Pressure Con-
trol Knob (number 4).