Tweco 400 Ultra-Cut(October 2014) - Manual (Page 37)

ULTRA-CUT 100 XT/200 XT/300 XT/400 XT
Manual 0-5264 INSTALLATION 3-11
3.12 Connect Cables for CNC, Remote Arc Starter, GCM and HE 400
1. Connect one end of each cable to the power supply.
2. Connect the other end of the CNC cable to the CNC device .
3. The CNC cable shield must be attached to ground at the CNC end.
USER INPUT
HEIGHT CONTROL
F1 - 8A SB 230 VAC F2 - 8A SB 230 VAC
CB4 - 5A 120 VAC
CB3 - 5A 24 VAC
CB2 - 5A 120 VAC
J55 - GCM
J15 - CNC
J59 - RAS
J70 - HE
J54 - TSC /COMM
Art # A-11971
J15 To CNC Control
J59 To Remote
Arc Starter
J55 To GCM
J70 To Heat
Exchanger
J54 TSC/
Comm
3.13 Handling and Installation of Fiber Optics
General Information
This kit is for proper handling and installation of Fiber Optic Cables used in Victor Thermal Dynamics Ultra-Cut ®
automated gas boxes and Gas Control Modules.
Fiber Optic cable is used in place of wire because it offers far superior immunity to electrical noise but it is more
delicate and requires careful handling. With fiber optics, electrical signals are converted to light with a transmit-
ter LED. The light passes down the fiber where it is converted back to an electrical signal at the receiver end. Any
damage to the fiber from sharp bends or pulling that stretches the fiber can reduce it’s ability to transmit light. We
run the fiber inside a hose for most of its length to protect it from abrasion, burning from hot metal or sharp bends
but the ends are exposed and must be handled with care.
Hose Strain Relief Fiber
Connector with Latch Protective End Covers
Art # A-09416