Tweco 300 XT Ultra-Cut Plasma Cutting System - Manual (Page 36)

ULTRA-CUT 300 XT
3-12 INSTALLATION Manual 0-5274
Avoid the following:
1. If you need to pull the cable through a power track do not fold the fiber back on itself making a sharp bend
where it exits the hose.
Art # A-09417
2. Don’t hook onto the fiber to pull on the cable.
Art # A-09418
3. Once the fiber cable is installed in the CCM or gas control make sure the strain relief nut is securely tightened
onto the hose so the hose can’t pull out of it like this:
Art # A-09677_AB
Hose not secured in
the Strain Relief