Ultra-cut 300 xt – Tweco 300 XT Ultra-Cut Plasma Cutting System User Manual
Page 42
Advertising
ULTRA-CUT 300 XT
3-18
INSTALLATION
Manual 0-5274
NOTE
The unit must be mounted so that the Flowmeters are plumb. If the Flowmeters are not plumb, incorrect flow
indications may occur.
Preparation
1. Remove the screws securing the Cover Panel to the Module.
2. Carefully remove the cover from the module noting the attached ground wire. Remove the ground wire if
needed.
Art # A-06882
Gas Control Module Cover
Do not remove
Remove Ground
Wire
Cover Removal
Advertising