Ultra-cut 300 xt – Tweco 300 XT Ultra-Cut Plasma Cutting System User Manual
Page 44
Advertising
ULTRA-CUT 300 XT
���
INSTALLATION
Manual ��5�74
. Insert the fiber�optic cable connector into the receptacle on the vertically�mounted circuit board as shown.
Cable must snap into place.
Circuit Board
Fiber Optic Cable
Art # A-04773
4. Tighten the through�hole protector for the fiber�optic cable using hand tools.
5. Reinstall the Cover Panel making sure the ground wire is attached.
Advertising