Tweco 300 TS Arcmaster(April2006) - Manual (Page 18)

12
SECTION 2: INTRODUCTION AND DESCRIPTION
2.01 How To Use This Manual
This Owner’s Manual applies to part number
10-3097.
To ensure safe operation, read the entire
manual, including the chapter on safety
instructions and warnings.
Throughout this manual, the words WARNING,
CAUTION, and NOTE may appear. Pay
particular attention to the information provided
under these headings. These special
annotations are easily recognized as follows:
WARNING
A WARNING gives information
regarding possible personal injury.
CAUTION
A CAUTION refers to possible
equipment damage.
NOTE
A NOTE offers helpful information
concerning certain operating
procedures.
Additional copies of this manual may be
purchased by contacting Thermal Arc at the
address and phone number given in the next
section. Include the Owner’s Manual number
and equipment identification numbers.
Electronic copies of this manual can also be
downloaded at no charge in Acrobat PDF
format by going to the Thermal Arc web site
listed below and clicking on the Literature
Library link:
http://www.thermalarc.com
2.02 Equipment Identification
The unit’s identification number (specification
or part number), model, and serial number
usually appear on a nameplate attached to the
control panel. In some cases, the nameplate
may be attached to the rear panel. Equipment
which does not have a control panel such as
gun and cable assemblies is identified only by
the part number printed on the shipping
container. Record this number for future
reference.
2.03 Receipt of Equipment
When you receive the equipment, check it
against the invoice to make sure it is complete
and inspect the equipment for possible
damage due to shipping. If there is any
damage, notify the carrier immediately to file a
claim. Furnish complete information
concerning damage claims or shipping errors
to the location in your area listed in the inside
back cover of this manual.
Include all equipment identification numbers
as described above along with a full
description of the parts in error.
Move the equipment to the installation site
before uncrating the unit. Use care to avoid
damaging the equipment when using bars,
hammers, etc., to un-crate he unit.