Tweco 300 TS Arcmaster(April2006) - Manual (Page 32)

26
4.04 Weld Parameters for ArcMaster 300 TS
Weld Mode
Weld
Parameter
Parameter Range Factory
Setting
Incremental
Unit STICK
HF
TIG
LIFT
TIG
PRE-FLOW 0.0 to 1.0 sec 0 sec 0.1 sec No Yes Yes
HOT START 0 to 70A 20A 1A Yes Yes No
INITIAL CUR. 5 to 300A 30A 1A No Yes Yes
UP SLOPE 0 to 15 sec 1 sec 0.1 sec No Yes Yes
PEAK CUR. 5 to 300A 120A 1A No Yes Yes
WELD CUR
(TIG)
5 to 300A 80A 1A No Yes Yes
WELD CUR (STICK) 5 to 300A 80A 1A Yes No No
SPOT TIME 0.5 to 5.0 sec 2 sec 0.1 sec No Yes Yes
PULSE WIDTH 15 to 80% 50% 1% No Yes Yes
PULSE FREQ. 0.5 to 500Hz 100.0Hz
See
Table 6
No Yes Yes
DOWN SLOPE 0 to 25 sec 3 sec 0.1 sec No Yes Yes
CRATER CUR. 5 to 40A 30A 1A No Yes Yes
POST-FLOW 0.0 to 60 sec 10 sec 0.1 sec No Yes Yes
Table 5 – Weld Parameters for ArcMaster 300 TS
PULSE FREQ. Range Incremental Unit
0.5 to 20Hz 0.1Hz
20 to 100Hz 1Hz
100 to 500Hz 5Hz
Table 6 – PULSE FREQ. Range and Incremental Units